Classic ten recruit help you maintain good digital camera batteries
Digital camera power consumption, even if the problem is a big problem with enough battery, because often should change the battery caused a lot of trouble, let alone without enough battery and cause digital camera cannot use of problem. Therefore, we are in charge with use process must pay attention to the correct method of use and maintenance matters.
When you purchase a new battery or several months used batteries, after several times with full release can be fully activate electronic, otherwise later battery life will is relatively short. Lithium battery charge hours must more than six hours, nimh batteries must more than 14 hours, so the battery can be completely filled. Use the original factory chargers and battery, will help battery life extension. For charging time, depends on the charger and used batteries, and whether the use of voltage stability, and other factors.
Battery has residual power, try not to repeat charging, to ensure the battery life. Even in digital camera battery
panasonic cga-du14 battery has run down, display, in fact, still have a bit of residual battery power. If the unused cases repeatedly to recharge the battery, then the battey using time slowly is shorter. Want to make use of time to recover the original level, be about to many times repeatedly "completely finished using it for recharging. This time we can use small electric to solve this problem. If the 5th rechargeable battery, and can be installed in the hand of the battery electric power exhausted after recharging.
Turn off the power consumption of large LCD display, convert optical viewfinder. If you have to be LCD display, best down its brightness or convert black-and-white. This can be fully saving energy, and extend the life of the battery.
Periodically will battery recharging after full discharge, the easiest way is to use adjusting charger or pulse charger.
Old and new batteries not at the same time is tie-in use. Even if the same brand of old and new batteries collocation can also lead to own damage, digital camera related circuit of also can have dangerous, so old and new batteries use of everybody must be attention.
Usually many charging problem was because the battery point of contact sordid and cause, so you should not regularly use dip in alcohol a swab to wipe clean battery point of contact.
Note charge with use of temperature, it is especially important for nimh batteries. Should be in 0 ° C to 40 ° C environmental temperature on the battery. Below 0 ° C will make battery charging under internal charging abnormal, causing unrecoverable performance continue to decline. Prep above 40 ° C charging, there will be led to the possibility of leakage.
If long time not to use the camera battery, will be removed from the camera, and put them in cold, dry place preservation.
Use no matter what kind of rechargeable batteries, are not suitable for charging into digital camera immediately after use, it's best to just filled out charged battery placed in a short while, do a little mainly because have just completed battery its closed loop voltage may have higher than the rated voltage value, if the camera to immediately loaded within the camera relevant circuit element influence. So, had better wait rechargeable batteries self-discharge to rated voltage again when use. Of course, also don't will be full of electrical rechargeable batteries long time in mothballs, such, to rechargeable batteries itself does not have the advantage.
Finally remind everybody a bit, if conditional AC voltage adapter can use the power, still had better use AC voltage adapter power, after all, rechargeable batteries
panasonic vw-vbk360 battery cost or high. Most digital cameras are equipped with adapter own AC voltage adapter power supply. Before use shall first make clear your AC adapter 110V voltage power supply is external, or 220V voltage, because, if plug-and-socket undeserved, easy to burn out power even camera. The more don't feel free to use other voltage adapter power, because, each camera manufacturer produces the camera in adaptive voltage, current, and specifications are differences, optional improper use of voltage adapter power, light is easy to damage the power of the camera interface, serious when likely due to voltage, current mismatch and burned-out camera. Therefore, to special remind attention.
Loading...